Identification of the Causes of Dirty Fuel Filters in Auto Workshops for Optimizing Vehiche Maintenance

Mahmud Basuki, Mahmud Muqorrobin, Marlinda Marlinda

Abstract


Fuel is one of the tools to drive the machining system that moves from the fuel tank to the engine. Although there are several areas that have switched to using electric vehicles, vehicles that use fuel oil still dominate the public in various countries. The purpose of this research is to identify the causes of a dirty fuel filter in an auto repair shop. The methods used in this analysis are Failure Mode and Effect Analysis (FMEA) and fishbone diagram analysis. Based on the results and discussion, the cause of the dirty fuel filter is the causal factor from the method side, namely due to negligence in maintenance, from the material side because the fuel tank is dirty and the fuel is not good, from the engine side because of continuous use without maintenance, from the human side because it is not routine maintenance, due to carelessness in maintenance, and due to frequent changes in the type of fuel.


Keywords


FMEA; fishbone diagram; fuel filter

Full Text:

PDF

References


Pertamina, “Spesifikasi produk BBM, BBN, & LPG”

A. Wicaksono & F. Yuamita, “Pengendalian kualitas produksi sarden menggunakan metode failure mode and effect analysis (FMEA) dan fault tree analysis (FTA) untuk meminimalkan cacat kaleng di PT XYZ,” Jurnal Teknologi dan Manajemen Industri Terapan (JTMIT), vol 1, no 3, pp. 145-154, September, 2022.

A.P. Tanto., D. Adesta., & M. Jufriyanto, “Analisis kecacatan produk dengan metode FMEA dan FTA pada produk meja OKT 501 di PT. Kurnia Persada Mitra Mandiri,” Jurnal Serambi Engineering, vol 8, no 2, pp. 5206-5216, April, 2023.

Hardiansah., Y. Sukmono., & W.W. Saptaningtyas, “Analisis risiko kecelakaan kerja dengan metode failure mode and effect analysis (FMEA) dan fault tree analysis (FTA) (studi kasus: bengkel dinamis),” JATRI - Jurnal Teknik Industri, vol 1 no 1, pp. 1-9, Februari, 2023.

M. Basuki, “Identifikasi cacat prioritas pada proses shaving untuk pengendalian mutu kualitas,” Jurnal Rekayasa Sistem dan Industri (JRSI), vol 6, no. 02, pp. 101-108, Desember, 2019.

M. Basuki., & R.U. Fahadha,“ Identification of the causes nata de coco production defect for quality control,” Spektrum Industri, vol. 18, no. 2, pp. 175-181, Oktober, 2020.

M. Basuki., S.B.W. Octaviani., & Lukas,“ Identification of causes in the dirty gas pipeline in oil and gas delivery process at JOB Pertamina Talisman Jambi Merang,” Journal of Industrial Engineering and Halal Industries (JIEHIS), vol. 3, no. 2, pp. 114-119, Desember, 2022.




DOI: http://dx.doi.org/10.52155/ijpsat.v38.1.5202

Refbacks

  • There are currently no refbacks.


Copyright (c) 2023 Mahmud Basuki, Mahmud Muqorrobin, Marlinda Marlinda

Creative Commons License
This work is licensed under a Creative Commons Attribution 4.0 International License.